Troubleshooting - Sony BRAVIA XBR-85X807H Reference Manual

Detaching the Table-Top Stand from the
TV
1
Remove one side of the Table-Top
Stand at a time. Firmly hold the
Table-Top Stand securely with both
hands while the other people lift up
the TV.
2
Repeat the previous step and
remove the other side of the
Table-Top Stand.
Note
• Three or more people are required to
detach the Table-Top Stand.
• Be careful not to use excessive force while
detaching the Table-Top Stand from the
TV as it may cause the TV set to fall
resulting in personal injury or physical
damage to the TV.
• Take care when handling the Table-Top
Stand to prevent damage to the TV.
• Be careful when lifting the TV as the
Table-Top Stand is detached, the
Table-Top Stand may topple over and
cause personal injury.
• Take care when removing the Table-Top
Stand from the TV to prevent it from
falling over and damaging the surface
that the TV is sitting on.
• Do not remove the Table-Top Stand for
any reason other than to install
corresponding accessories on the TV.
• Be sure the TV is vertical before turning
on. To avoid uneven picture uniformity do
not power on the TV with the LCD panel
facing down.
XBR-49X805H
To detach the Table-Top Stand from the
TV, remove the screws.
Note
• Do not remove the Table-Top Stand for
any reason other than to install
corresponding accessories on the TV.
• Be sure the TV is vertical before turning
on. To avoid uneven picture uniformity do
not power on the TV with the LCD panel
facing down.
• When attaching the Table-Top Stand
again, be sure to fasten the screws
(previously removed) to the original holes
on the rear of the TV.
• Place the TV with its screen facing down
on a level and stable surface covered with
a thick and soft cloth when removing the
Table-Top Stand from the TV to prevent
damaging the surface of the LCD display.

Troubleshooting

General troubleshooting for issues like:
black screen, no sound, frozen picture, TV
does not respond, or network is lost, do the
following steps.
1
Restart your TV by pressing the power
button on the remote control for about
five seconds. After twenty seconds, press
the power button on the remote control.
If the TV does not recover, try
unplugging the AC power cord. Then
press the power button on the TV, and
release it. Wait for two minutes, and plug
in the AC power cord.
11 US