Introduction
1.5. Output Pulse Clock Speed
The output sine and cosine pulse trains are interpolated to spread out the pulses evenly throughout the .5 µs
sample period. The output pulse can be clocked at four different frequencies depending on the input
frequency and the pulse width jumper settings. The output clock can be 4 MHz, 8 MHz, 16 MHz, or 32 MHz.
The following chart in
Figure 1-8
Sixteen counts per .5 µ second sample period generates the maximum of 32 million counts per second.
32 MHz
1 count
2 counts
3 counts
4 counts
5 counts
6 counts
7 counts
8 counts
9 counts
10 counts
11 counts
12 counts
13 counts
14 counts
15 counts
16 counts
www.aerotech.com
shows the count spacing over a .5 µs period with the clock set to 32 MHz.
.5 µ Second
Figure 1-8:
32 MHz Count Spacing
Chapter 1
MXH Multiplier Option Manual
21