Figure 1-2: Mxh Multiplier Board Configuration; Table 1-1: Order Option Summary - Aerotech MXH Series Hardware Manual

MXH Multiplier Option Manual
The MXH multiplier board connects between the encoder and the appropriate axis controller. Refer to
1-2 for an example configuration. This connection does not affect Hall effect or limit signals; instead, it is a
simple add-in that uses mostly standard cables.
Table 1-1: Order Option Summary
MXH Series Multiplier
MXH50
MXH100
MXH200
MXH250
MXH500
MXHn-D
Input Signal
D
Output Data Rate
2M
4M
8M
16M
32M
Note: MXH multipliers are available in -A and -B versions as factory supplied configurations. Multiplication selections are possible in
0.25 increments up to MXH256, which multiplies into an integer after x4 (i.e. 0.25 or 0.5, 1.25, 33, etc. Unacceptable values are 1.7,
2.4, etc.). From MXH256 to MXH512, multiplication selections are possible in x1.0 increments.
10
Figure 1-2: MXH Multiplier Board Configuration
External 50-times (net 200-times interpolation with quadrature) multiplier
External 100-times (net 400-times interpolation with quadrature) multiplier
External 200-times (net 800-times interpolation with quadrature) multiplier
External 250-times (net 1000-times interpolation with quadrature) multiplier
External 500-times (net 2000-times interpolation with quadrature) multiplier
External "n"-times custom resolution. Consult factory
1 Vpp input signal
2 MHz output signal
4 MHz output signal
8 MHz output signal
16 MHz output signal
32 MHz output signal
Chapter 1
Introduction
Figure
www.aerotech.com