Potentiometers; Output Options; Table 1-8: Mxh Multiplier Board Potentiometers; Table 1-9: Digital Differential Factory Options - Aerotech MXH Series Hardware Manual

MXH Multiplier Option Manual

1.4.7. Potentiometers

For the location of the pots on the MXH multiplier board, refer to
Table 1-8: MXH Multiplier Board Potentiometers
Pot Function
R14 Phase adjust between sine and cosine signals
R15 Balance for encoder cosine signal
R16 Gain adjust for encoder cosine signal
R17 Balance for encoder sine signal
R18 Gain adjust for encoder sine signal

1.4.8. Output Options

The following Digital Differential factory options are available; refer to
and Figure 1-15. All four of these options provide RS-422 differential square wave output signals produced
after multiplication. Options 1-3 add additional outputs providing RS-422 signals from the un-multiplied input
signals
Table 1-9: Digital Differential Factory Options
Option Code Description
NONE Differential square wave sine / cosine multiplied signals (standard)
-1 Differential square wave output of un-multiplied sine signal
-2 Differential square wave output of un-multiplied sine and cosine signals
-3 Differential square wave output of un-multiplied sine, cosine and marker (unqualified)
signals.
20
Figure 1-6.
Figure
Chapter 1
Introduction
1-12, Figure 1-13, Figure
www.aerotech.com
1-14,