Cleaning Modes - Shark Vertex DuoClean PowerFins AZ2000 Series Owner's Manual

WHOLE-HOME CLEANING
POWER SWITCH
Press power button to turn on vacuum.
Please note the brushrolls will not spin
unless the wand is reclined.
BRUSHROLL INDICATOR LIGHT
INDICATOR LIGHT
WHAT DOES THE BRUSHROLL INDICATOR LIGHT MEAN?
Solid Green: The brushrolls are spinning and working as they should.
Solid Red: There is a jam in the brushroll area. Turn off the vacuum and unplug it, then remove
any blockages in the nozzle.
Flashing Red: The motorized floor nozzle is overheating. Turn off the vacuum, unplug it, and
remove any blockages. Let the vacuum cool down for at least 60 minutes before restarting.
See Troubleshooting section for more information.
NOTE: For deep cleaning per ASTM F 608 (embedded dirt in carpets) please set to Carpet/Low Pile.
NOTE: For maximum suction for above-floor cleaning per ASTM F558, set to Hard Floor mode.
s h a r kc l e a n . c o m
SETTINGS
SURFACE SELECTOR
Thick Carpet & Area Rug Cleaning
Slide the surface switch to the top position
to select Thick Carpet/Area Rug.
Carpet & Low Pile Cleaning
Slide the surface switch to the middle position
to select Carpet/Low Pile to increase the
speed of the brushrolls and to help remove
stuck-on dust and debris.
Hard Floor Cleaning
Slide the surface switch to the bottom
position to select Hard Floor.
NOTE: Try using Hard Floor mode for low pile area rugs.
WHOLE-HOME CLEANING

CLEANING MODES

UPRIGHT
To engage brushrolls, step on floor nozzle
and tilt handle back.
ABOVE-FLOOR—HANDLE
Press the Handle Release latch to detach the
handle from the wand.
POWERED LIFT-AWAY®
Press the Lift-Away button to detach the pod
from the floor nozzle.
NOTE: All accessories are compatible with both the wand and the handle.
ABOVE-FLOOR—WAND
Press the Wand Release button to detach the
wand from the pod.
LIFT-AWAY®
With pod removed, press the Wand Release
button to detach the wand from the floor
nozzle.
s h a r kc l e a n . c o m