Summary of Contents for Streamline CLAWFOOT R-5000-69CICFRD-FM
Page 1
CLAWFOOT BATHTUB SERIES OWNER'S MANUAL & INSTALLATION GUIDE READ ENTIRE INSTALLATION GUIDE PRIOR TO INSTALLING THE BATHTUB THIS BATHTUB SHOULD ONLY BE INSTALLED BY A CERTIFIED PLUMBER CAUTION! TWO PEOPLE ARE REQUIRED TO LIFT THE BATHTUB QUESTIONS ON PRODUCT, INSTALLATION, RETURNS? PLEASE CONTACT support@streamlinebath.com 1 (323)-612-8011 streamlinebath.com...
Building and plumbing codes may vary state-to-state. Streamline shall not be held liable for any and all incidental damages or flood caused due to use of this product. Streamline shall not be held liable for any and all fees stemming from cost of installation, re-installation, removal, subsequent damage, or transportation in a case of a product defect.
Page 5
CLAWFOOT CONFIGURATION Clawfeet: R-CFL03, R-CFL04, R-CFL06, R-CFL-20 have specific foot placement. Each foot in the set is unique. Inside each foot is labeled with a letter to help you find the proper location on the tub for installation. Match up the letters on the clawfeet with the letters on the underside of the tub.
Page 7
BATHTUB INSTALLATION Ensure that the floor at the installation site has sufficient floor support and is level. Waterproofing the floor is highly recommended. Determine the location of the drainpipe on the floor by taking measurements of the drain and waste location underneath the unit.
Page 8
Gently place the bathtub in the upside-down position on a tarp or cardboard sheet in order to avoid contact with any rough surface. Take (1) adjustable foot [#1], place it through the hole in the clawfoot [#2], Place (1) rubber washer [#5] and place it over the bolt [#6] Take the clawfoot [#2] and place it over over the rubber washer [#5] and bolt [#6].
Page 9
Take (1) nut [#3] and place it over the the washer [#4]. Make sure to adjust the clawfoot so that it fits snug with the bolts on the bathtub. This will help to ensure that the clawfeet are placed correctly and are functioning properly. Tighten the nut [#3] with a wrench and adjust the clawfoot as needed.
Page 10
Take the strainer, place silicone sealant around it, and then place it into the drain hole ensuring a tight connection with the drain ell & gasket. Use silicone sealant. DO NOT use plumbers putty to seal. Silicone Sealant Strainer Gasket Drain Ell Insert the tailpiece into the trap inlet using the O-ring, coupling nut, &...
Page 11
14 . Attach the tapered rubber gasket to the overflow ell. Align the overflow ell with the overflow hole & secure the drain to the tub with overflow plate and screw provided. Tapered Rubber Gasket 15 . Make sure a watertight seal exists on all bath drain connections. Drain Pipe Cover Floor...
Need help?
Do you have a question about the CLAWFOOT R-5000-69CICFRD-FM and is the answer not in the manual?
Questions and answers