Streamline K-92-70FSWHSS-FM Owner's Manual & Installation Manual

Product Care and Maintenance
In order to clean the bathtub, please only use soft cotton cloth or
soft sponge.
Silicone
Never use acidic, alkali, or any products that state on their label
that they are not suitable for use on Acrylic, ABS, Polystyrene or
Measurement
Plastic to clean the bathtub.
To clean inside, fill it with warm water and add a couple of squirts
of dish liquid. Allow it to sit for 30 minutes. Let the bathtub drain
and wipe away the residue. You can also use cleaning products in
aerosol cans or solvents, including acetone to deep clean.
To remove light marks / scratches apply toothpaste to the area and
scrub with soft cloth/sponge.
3 2
1. Move the bathtub into the desired location and mark on the floor along
1. Move the bathtub into the desired location and mark on the floor along bathtub's bottom.
bathtub's bottom.
2. Set the bathtub upside down on a nonabrasive surface. Loosen the nuts and washers
2. Gently lift the tub and adjust the leveling feet to desired height by from the metal frame. Adjust the leveling feet to align with bathtub's bottom as well as level
the tub with the floor and then tighten the washers and nuts.
rotating them.
3. Move the bathtub back into the desired location and put the drain hose into the floor drain.
3. Move the bathtub back into the desired location and put the drain hose
into the floor drain.
4. Apply silicone along the bottom of the bathtub to create airtight seal.
4. Apply silicone along the bottom of the bathtub to create airtinght seal.
6
Bathtub Installation
Pencil
Wrench
Level Bar
2
3
Owner's Manual & Installation Guide
Please read all instructions carefully before proceeding with
installation.
Due to the complexity of the installation procedure a professional
plumber is required.
Specifications and directions may change without notice.
2 3
Freestanding Bathtub