Maintenance & Care - Bissell CleanView ProHeat 1456G User Manual

Maintenance & Care
Machine Care
For best results, a few simple steps can assure
your machine is well maintained after your
cleaning is complete.
1. Flush your machine of any remaining
residual formula.
a. Fill 2-in-1 Water Tank with clean warm
(60°C/140°F MAX) tap water.
b. Recline handle and press Spray Trigger
for 15 seconds while making forward and
backward passes on carpet. Release Spray
Trigger and make forward and backward
passes for another 15 seconds or until there
is no more water being suctioned up from
the carpet.
2. Press Power Button
and wrap Power Cable.
3. After emptying the 2-in-1 Water Tank, rinse top
half of tank through nozzle area. Rinse bottom half
of tank with running warm (60°C/140°F MAX) tap
water, taking care to clean underneath and around
the heavy-duty bladder. Be sure to also empty and
rinse hair and debris basket inside tank.
4. Remove any debris on red filter near air duct
on back of base of machine.
5. Keeping the 2-in-1 Water Tank off the base of machine,
remove nozzle by turning locking keys to "unlock" position
and lifting up. Rinse nozzle in clean, running water.
6. Any loose hair or debris can be pulled from Brush
Rolls and thrown away. For the most thorough clean
before storage, follow directions on pages 13 and 14
for removing and replacing the belts and Brush Rolls.
7. Replace nozzle by lining up locking keys with
their slots and placing nozzle back onto foot of
machine. Secure into place by turning locking
keys clockwise to "lock" position.
8. To clean suction diverter, remove two screws
on back of diverter housing. Take diverter
housing to a sink and rinse it with clean, running
water. Take care to remove any debris that
may build up and cause a clog. Replace diverter
housing and two screws.
9. To clean attachments, remove from Hose and
rinse under clean, running water. Dry before
storing. Clean hose by suctioning clean water
from tap (taking care not to let tank overflow).
Before wrapping back onto machine, lift end
of hose and stretch out to ensure all water is
cleared from hose. (See illustrations 7 and 8
on page 10.)
10. Wipe machine's exterior with a soft cloth.
11. After carpet is dry, you may wish to vacuum
again to remove any leftover hair and fuzz the
carpet & upholstery washer may have brought to
the carpet surface.
12
BISSELL.com
OFF. Unplug machine
WARNING
To reduce the risk of electric shock, push Power Button
OFF and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Tip
» Let all parts
dry completely
before storing
60C 4.
5.
Nozzle locking keys
8.
Filter
Suction
diverter