Bissell CleanView ProHeat 1456G User Manual page 11

Operation s
Cleaning with Attachments (cont.)
Stain Trapper Tool
1. Slowly move the tool back and forth over the
stain. Be careful not to move the tool back and
forth too quickly or soiled water will flow back
into the hose.
2. To empty the Stain Trapper Tool, rotate the
small tank on the bottom of the tool to unlock it.
3. Dump dirty water into a sink or toilet and rinse
the tank out with clean water.
4. Replace the tank by lining up the locking
teeth with their mating slots (make sure the
two teeth that are closest together are pointed
toward the brush). Turn the tank to lock it into
place.
5. Clean the front of the tool by removing the
plate over the suction plate. Pull down to remove
and rinse with water. Then replace the plate by
sliding back into place.
TurboBrush® Tool
The powerful rotating TurboBrush® loosens and
removes deep-down dirt. Attach the Powered
TurboBrush® Hand Tool to the hose of your
carpet washer and use the tool to loosen
tough stains and dirt deep into your carpet or
upholstery.
IMPORTANT
Check for colourfastness in an inconspicuous place. If
possible, check upholstery stuffi ng. Coloured stuffi ng may
bleed through fabric when it becomes wet.
1.
3.
2.
4.
BISSELL.com
11