Front Panel/Rear Panel; Power Switch; Power Indicator - Yamaha MSP3 Owner's Manual

Front panel/Rear panel

LOW HIGH
1 2
1 LOW control
This control knob enables you to adjust the bass in the
range of –3dB to +3dB based on a reference value of
100Hz. The bass range is flat with the knob set at 12
o'clock, boosted when the knob is turned clockwise,
and cut when the knob is turned counter-clockwise.
2 HIGH control
This control knob enables you to adjust the treble in
the range of –3dB to +3dB based on a reference value
of 10kHz. The treble range is flat with the knob set at
12 o'clock, boosted when the knob is turned clockwise,
and cut when the knob is turned counter-clockwise.

3 Power indicator

This indicator lights up green when you turn the
POWER switch on the rear panel ON.
4 LINE 1 level control
This control knob enables you to adjust the volume
level of the signal input at the INPUT LINE 1 jack ( 7 )
on the rear panel. Turning the knob counter-clockwise
lowers the volume level, and turning it clockwise raise
the level.
1 LINE 2
3 4 5
5 LINE 2 level control
This control knob enables you to adjust the volume
level of the signal input at one of the INPUT LINE 2
jacks (8) on the rear panel. Turning the knob counter-
clockwise lowers the volume level, and turning it clock-
wise raises the level.
6 8
POWER
ON
OFF

6 POWER switch

This switch turns the power to the MSP3 on and off.
When you turn this switch on, the power indicator
( 3 ) lights up green.
7 INPUT LINE 1 jack
This input jack is used to connect an RCA pin plug.
8 INPUT LINE 2 jacks
These balanced jacks are used to connect an XLR-3-31
type connector or a TRS phone plug to input line-level
signals from a mixing console.
CAUTION
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
7
INPUT
LINE 1
(–10dB)
LINE 2
(+4dB)
PARALLEL
5