Table of Contents
Advertisement
WellPrint System User Manual
2. Software debugging steps
2.1Calibrated gear ratio
Firstly, mark the material, then fill in 100 after the Move, clicks the Move. Mark the material
again after its move is completed. Measuring the actual moving distance with a ruler, fills in the Run
length, and click Calculate.（Note: only click one time of Calculate each time）
The second time, fill in 300, click Move， measure the actual run length, and then click the Calculate.
The third time, fill in 600, click Move， measure the actual run length, and then click the Calculate.
第 16 页 /共 34 页
Click the Maintenance, Motion
setting，you can see the left picture as
shown.
Firstly,
fill
value(100) after the Move, click the
Move, at the same time, the software
will display the cartridge position in
the left bottom
corner(if it shows
negative，it means the raster decoder is
backwards in polarity, changing its A
and B line decoder sequence, eventually
restart
the
machine).
Reposition, and then fill in a larger value,
half of the format width, and then click
the Move, click Reposition after the
cartridge position stops. Finally, fill in the
format width size; click Move, and the
click Reposition.
WellPrint
in
a
smaller
Click
the
Hide quick links:
Advertisement
Table of Contents
