Table of Contents
Advertisement
To remove the power supply:
1.
Turn off the circuit breaker of the power cord.
2.
Put on the ESD wrist strap, making sure the strap makes good skin
contact and is well grounded.
3.
Loosen the cable tie, and remove the power cord.
4.
As shown in
the power supply along the guide rails until it is part-way out.
5.
Grasp the handle of the power supply with one hand, and hold
the bottom of the power supply with the other hand to pull the
power supply slowly along the guide rails out of the slot.
Figure 9 Removing the power supply
Figure
9, press the latch towards the handle, and pull
1
2
12
Advertisement
Table of Contents
