Table of Contents
Advertisement
To install the power supply:
1.
Put on the ESD wrist strap, making sure the strap makes good skin
contact and is well grounded.
2.
Unpack the power supply and verify that the power supply model
is as required.
3.
As shown in
the handle of the power supply with one hand and the bottom of
the power supply with the other, and then slide the power supply
slowly along the guide rails into the slot. When the power supply
is completely inserted into the slot, you can hear that the latch of
the power supply clicks into the slot.
Figure 3 Installing the power supply
Figure
3, with the upside of the power supply up, hold
7
Advertisement
Table of Contents
