Keyboard Stand Assembly - Yamaha YDP-131 Owner's Manual

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the included screws only, and insert screws of the correct size in the correct hole locations. Do
not use any other screws. Use of incorrect screws can cause damage or malfunction of the product.
• Be sure to tighten up all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready
Remove all parts from the package and make sure you have all of the items.
D
Bundled pedal
cord inside
Assembly Parts
6 × 20 mm long screws ×4 1
6 × 16 mm short screws ×4 2
4 × 12 mm thin screws ×2 3
34

Keyboard Stand Assembly

YDP-131/YDP-213
A
E
B
C
AC power adaptor
4 × 20 mm tapping screws ×4 1
Cord holders × 2
1.
Attach (finger-tighten) C to D and E.
1-1 Untie and straighten out the bundled pedal
cord. Don't discard the vinyl tie. You will
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6 × 20mm).
1-2
E
C
1-3
2.
Attach B.
Depending on the model of digital piano you
purchased, the surface color of one side of B may
be different from the other side. In this case, posi-
tion B so that the side of the surface color similar
to D and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws 3 (4 × 12mm).
2-3 While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws 4 (4 × 20mm).
2-4 Insert the other two tapping screws 4 (4 ×
20mm) into the other two screw holes to
secure B.
D
1-1