Front Panel - Fender Passport Conference 2 Series Owner's Manual

A. MASTER VOLUME: Adjusts overall loudness. No sound is
produced at full counterclockwise position.
B. SIGNAL/CLIP LED: Illuminates green when signal is
present; yellow when signal level is -10dB away from
clipping. Illuminates red during clipping (see step 9 under
SYSTEM SETUP).
C. CHANNEL VOLUME: Adjusts individual channel
loudness.
D. TONE: Adjusts individual channel tone, with "flat"
frequency response at center-detented position.
E. MIC/LINE SWITCH: If signal source level is too high (see
step 9 under SYSTEM SETUP), press in to reduce input
sensitivity by 24dB.
F. MONO CHANNEL INPUT: XLR and 1/4" input for
microphones, instruments and other mono line-level
sources for channels 1, 2 and 3.
G. PAIR BLUETOOTH: Press for Bluetooth pairing with
external devices. When button is flashing blue, select
"PASSPORT CONFERENCE" in external device Bluetooth
menu. Button will stop flashing and illuminate blue
continuously when connection is successful. Press and
hold button to disconnect Bluetooth. For best sound
quality, set volume control on external device (i.e., smart
phone) to 75-100 percent of its maximum level.
H. 1/4" LEFT (MONO)/RIGHT INPUT: Inputs for line-level
stereo audio sources requiring separate 1/4" jacks
for each channel. Using stereo L/MONO jack by itself
functions as mono channel; mono output will be heard
from both speakers.
I. 1/8" STEREO INPUT: Input for mobile devices, computers
and other line-level stereo audio sources with 1/8"
connection.
J. HEADPHONE OUTPUT: Connect headphones and
recording equipment here. Individual channel controls
affect this output; MASTER VOLUME (A) does not.
K. LEVEL CONTROL: Adjusts HEADPHONE OUTPUT (J)
signal level.
L. POWER LED: Illuminates green when system is on.
Passport features internal protection measures that will
shut down audio output in the event of electrical or
thermal problems; Passport will automatically reset itself
on resolution of such problems. If Passport does not reset
automatically, check fuse in power cord socket on rear
panel (P).

FRONT PANEL

3