Position Columns And Locking Latch Plates - Launch TLT440 Installation Manual

LAUNCH

5.2.4 Position columns and locking latch plates

Place the power unit column at the FL (front left) corner
l
of the lift. The hydraulic cylinder connection in the left
runway should be visible from this corner. Position other
three columns.(Fig.9)
Thread the jam nut down the threaded stud of locking
l
latch plate as far as possible. Place the latch plate in the
R L Co lu mn
www.diagtools.eu, Pernavas 43A, Riga, Latvia, LV-1009, +37129416069, info@diagtools.eu
FL C ol um n
L ef t Ru nw ay
R ea r C ro ss T ub e
440(440W) 455(455W) Installation Manual
前梁
后 梁
Fig.8
back of the column (Fig.4). The latch plate should be
oriented toward the back of the column from the centre
line of the threaded stud.
l Place the FRL (filter, regulator and lubricator) bracket on
the power unit column.
l Threaded the adjustment nut down the threaded stud
until the nut and the top plate are flush, repeat for other
columns.
F ro nt C ro ss T ub e
R ig ht R un wa y
RR C ol um n
Ca bl e
Fig.9
10
FR C ol um n