D) Deleting All Saved User Transponders - Renkforce READER6 Operating Instructions Manual

d) Deleting all Saved User Transponders

Individual user transponders cannot be deleted separately.
If the master transponder is held against the aerial module for more than 10 seconds,
the control module deletes all saved user transponders and then automatically switches
to the teaching mode for user transponders.
Proceed as follows:
• Hold the master transponder against the aerial module.
• After 3 seconds, the LED (9) on the control module flashes 2x. Continue to hold the
master transponder against the aerial module.
• After another 7 seconds, the LED flashes 2x again. Now the user transponders are
deleted and the teaching mode for the user transponders is started automatically.
• Remove the master transponder from the aerial module.
• If user transponders should be taught in, hold the transponders intended for this to
the aerial module in sequence now (see chapter 10. c).
After recognition and saving of a new transponder as user transponder, the
10-second duration for the teaching mode starts again.
If another user transponder is to be taught in, hold it against the aerial module
within the 10 seconds.
If no other user transponder is to be taught in, wait for at least 10 seconds
(without holding any transponder against the aerial module) until the control
module automatically ends teaching mode; the LED (9) flashes 3x.
If no transponder is held against the aerial module within 10 seconds, the teaching
progress is ended, the LED (9) flashes 3x.
33