Using Your Instrument With Other Devices; Connecting Audio & Video Devices; Using External Audio Devices For Playback (1 [Output] Jacks); Playing External Audio Devices With The Built-In Speakers (2 [Aux In] Jacks) - Yamaha PortaTone PSR-S700 Owner's Manual

Using Your Instrument with Other Devices

CAUTION
Before connecting the instrument to other electronic
components, turn off the power of all the components.
Also, before turning any components on or off, make sure
to set all volume levels to minimum (0). Otherwise, elec-
trical shock or damage to the components may occur.
Connecting Audio & Video
Devices
n
Use audio cables and adaptor plugs having no (zero) resistance.
Using External Audio Devices for Play-
back (1 [OUTPUT] jacks)
You can connect these jacks to a stereo system to
amplify the instrument's sound. The microphone or gui-
tar sound connected to the instrument's [MIC/LINE IN]
jack is output at the same time. Use audio cables for
connection as shown in the diagrams. These jacks are
located on the underside jacks panel of the instrument.
CAUTION
• When the instrument's sound is output to an external
device, first turn on the power to the instrument, then
to the external device. Reverse this order when you turn
the power off.
• Do not route the output from the [OUTPUT] jacks to the
[AUX IN] jacks. If you make this connection, the signal
input at the [AUX IN] jacks is output from the [OUTPUT]
jacks. These connections could result in a feedback loop
that will make normal performance impossible, and
may even damage both pieces of equipment.
P. 200 P. 199 P. 198
9 8 7
USB
LAN
TO DEVICE
TO HOST
1 2
P. 193 P. 193
P. 198 P. 194 P. 194
6 5 3
MIDI FOOT PEDAL
VIDEO OUT
IN OUT 1 2
4
P. 194
When these are connected, you can use the instrument's
[MASTER VOLUME] control to adjust the volume of the
sound output to the external device. Connect the instru-
ment's OUTPUT [L/L+R]/[R] jacks (standard phone
jacks) and the input jacks of a pair of powered speakers
using appropriate audio cables. Use only the [L/L+R]
jack for connection with a monaural device.
Instrument
Phone plug
(standard)
Audio cable
Playing External Audio Devices with the
Built-in Speakers (2 [AUX IN] jacks)
The stereo outputs from another instrument can be con-
nected to these jacks, allowing the sound of an external
instrument to be reproduced via the instrument's speak-
ers. Connect the output jacks (LINE OUT etc.) of an
external synthesizer or the tone generator module and
the instrument's AUX IN [L/L+R]/[R] jacks using appro-
priate audio cables.
Instrument
Phone plug
(standard)
Audio cable
CAUTION
When the sound of an external device is output to the
instrument, first turn on the power to the external device,
then to the instrument. Reverse this order when you turn
the power off.
n
• Use only the [L/L+R] jack for connection with a monaural device.
• The instrument's [MASTER VOLUME] setting affects the input
signal from the [AUX IN] jacks.
PSR-S900/S700 Owner's Manual
Powered speakers
Input jack
Phone plug
(standard)
Synthesizer
Tone generator
LINE OUT
Pin plug
193