Sample cooler type
DTC-DCCP
Cooler cooling water connections
1/4 inch tube fitting
Cooling water consumption
0.2 gpm (0.8 Lpm) at 22°C (71.6°F)
Input power
DCCP-x1xxx: 110–120 VAC, 1 phase, 50/60 Hz
DCCP-x2xxx: 220–240 VAC, 1 phase, 50/60 Hz
Power consumption
1.6 KVA
Cell holders (optional)
3/4 inch FNPT, 316 SS
Resin column (optional)
Sentry RC-100
Indoor/outdoor use
Altitude: Up to 6,561 ft (2,000 m)
Ambient temperature: 36°F to 122°F (2°C to 50°C)
Relative humidity: 0% to 85% RH
Pollution degree 2
Overvoltage Category II
Main supply voltage fluctuations up to ±10% of the nominal voltage
Installation
Sharp Edges! Wear gloves when lifting and carrying the panel as edges could be sharp .
To ensure proper alignment and safe installation, lifting and carrying should be completed by at
least two people .
This instrument should be installed by qualified technical personnel to ensure adherence to all
applicable codes .
Use proper connection sizing to avoid an unsafe condition . This product comes standard with
1/4" compression fittings for the sample inlet/outlet, and 1/4" compression connections for the
cooling water inlet/outlet . Never attempt to install a metric equivalent tube, pipe, or fittings into
these connection points .
Lift unit by the stainless steel backplate . Do not lift using mounted components as these could
break, damaging the equipment and possibly causing personal injury .
Sentry DCCP Reboiler
7