Subscribe to Our Youtube Channel
Related Manuals for Sentry TSV
Summary of Contents for Sentry TSV
- Page 1 Installation, Operation and Maintenance Manual Temperature Shut-off Valve SPD 13.1.2 Rev. 6 10/07 SENTRY EQUIPMENT CORP PO Box 127 Oconomowoc, WI 53066 USA Phone: 262.567.7256 Fax: 262.567.4523 Email: sales@sentry-equip.com www.sentry-equip.com...
-
Page 2: Table Of Contents
SPD 13.1.2 Rev. 7 TABLE OF CONTENTS SAFETY PRECAUTIONS ....................iii General Description ....................1 Installation ......................2 Operation ......................3 Maintenance......................3 Technical Data ......................4 Warranty Conditions & Limitations ................5 SENTRY EQUIPMENT CORP • 262.567.7256 • Fax: 262.567.4523 • sales@sentry-equip.com • www.sentry-equip. com... - Page 3 NOTICE The information contained in this document is subject to change without notice. Sentry Equipment Corp, its employees, agents, and the authors of and contributors to this document specifically disclaim all liabilities and warranties, express and implied (including warranties of...
-
Page 4: Safety Precautions
CAUTION used without the safety alert symbol indicates a potentially hazardous situation, which if not avoided, may result in property damage. NOTE Information that requires special emphasis SHALL This word understood to be mandatory SHOULD This word understood to be advisory SENTRY EQUIPMENT CORP • 262.567.7256 • Fax: 262.567.4523 • sales@sentry-equip.com • www.sentry-equip. com... - Page 5 Improper selection, installation, or use can cause personal injury or property damage. Sentry does not warrant against erosion and corrosion. Sentry makes no claims regarding suitability for specific use, and provides no warrantee regarding material compatibility of elastomers in specific services.
-
Page 6: General Description
The TSV is a spring loaded, latching design with all wetted metals of 316SS construction. An optional position indicating dry contact (Sentry part # 4-05144A) is available to provide remote indication capabilities. -
Page 7: Installation
If the TSV is to be mounted vertical, it is recommended that the orientation be with the reset button up. If the TSV is to be mounted horizontal, it is recommended that it be positioned with the inlet at the top. -
Page 8: Operation
If the TSV trips during sampling operations, isolate the analyzers on the line or lines affected. Correct the problem causing the excessive sample temperature and reset the TSV. It may be necessary to hold the reset button in momentarily until the TSV will reset. After the TSV is reset, reinitialize sample flow to the analyzers. -
Page 9: Technical Data
All Sentry TSV’s pass a rigid operational and leakage test before leaving the factory. This valve is not user serviceable. If these instructions are not fully complied with, the product may fail and cause damage to property or injury to persons. -
Page 10: Warranty Conditions & Limitations
Warranty Conditions & Limitations This Warranty shall not apply to any Sentry product which, in the opinion of Sentry Equipment Corp, has been (a) altered or repaired in a manner affecting the efficiency of performance of the unit or (b) incorrectly installed or operated or (c) damaged in shipment or (d) damaged by flood or fire or (e) if the serial number is missing, altered or defaced. - Page 11 5. The factory will not process warranty claims until the customer has properly accomplished the above items. 6. The Sentry factory may accept the entire claim, a part of the claim, or none of the claim if our inspection of returned parts proves the failure was for reasons other than defective material or factory workmanship.
Need help?
Do you have a question about the TSV and is the answer not in the manual?
Questions and answers