WilTec JH95A Operation Manual page 6

Lubricant
We advise the use of 50g of special lubricant after 40 hours of continuous operation.
1. The Jackhammer offers a maximum lubricant capacity of 140ml, but it is advised to use a
maximum of 100 ml.
2. If the lubricant level should drop beneath the red mark of the lubricant level gauge, make sure
to refill it in order to guarantee the functionality of the tool. The lubricant level gauge should
thereby be checked every 30 hours of usage.
Lubricating
Loosen the grease cap with a spanner, remove it and fill the grease into the opening.
Starting
1. Before starting this device for the very first time, press the primer a few times in order to sup-
ply its system with fuel (figure 4).
2. Hold the hand grip with one hand and quickly pull the recoil start with the other until its cable
reaches a length of about 50 cm. Do not let the recoil start rebound freely and instead guide it
back in order to protect the starter.
3. Open the ventilation once the motor has been started.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
October 2019 Version 2
Seite 6