Program Change Receive Table - Yamaha P-100 Owner's Manual

Program change receive table

The P-100 is also capable of changing its current voice selection in response to program change messages it receives
from external devices. Before it left the Yamaha factory, your P-100 was set so that program change numbers 1
through 10 will select the corresponding voices: program change 1 will select PIANO 1, program change 2 will select
PIANO 2, and so on. Program change numbers above 10 were set to have no effect.
These settings are grouped in a table known as the program change receive table. This is a table which assigns a
P-100 voice selection to each of the 128 program change numbers. The procedure for changing the assignments in this
table is described below.
42
1. Enter MIDI Utility mode.
Press the [PC RECV] button while holding down the [MIDI]
button. A program change number will appear in the display,
and the LED above the [VOICE/UTILITY] button which has
been assigned to this program change number will light. (If no
button has been assigned to the program change number in
question, none of the [VOICE/UTILITY] button LEDs will
light.)
2. Select a program change number.
Use the [DATA ENTRY] slider or the [-1] and [+l] buttons to
select the desired program change number, or jump to step 3 if
you wish to change the setting for the current program change
number.
You can select any program change number from 1 to 128.
If you wish, you can make your selection using a MIDI message
instead of the [DATA ENTRY] slider. To do this, have an
external device transmit the desired program change number on
the P-100's program change receive channel. The number of the
message you send will appear in the P-100's display.
When you select a program change number, the LED above the
[VOICE/UTILITY] button for the voice which has been
assigned to that number will light. (Again, if no button has been
assigned to the program change number in question, none of the
[VOICE/UTILITY] button LEDs will light.)
3. Select a voice.
Press the [VOICE/UTILITY] button for the voice you wish to
assign to the program change number you have selected.
The LED above the button you press will light.
You can also turn the program change receive function off for
the selected program change number by pressing the button a
second time. When you do so, the LED above the button will go
out.