Calibration Procedure - Hyundai VERACRUZ ix55 Owner's Manual

Calibration procedure

The compass may not indicate the cor-
rect compass direction if the electronic
compass has not been calibrated cor-
rectly, if the compass zone number is dif-
ferent for your current location, or when
you are driving in certain areas (tunnel,
parking garage, underground parking lot,
near transformer substation, etc.), and
the following may occur:
• The compass headings become inac-
curate.
• The compass heading doesn't change
when the vehicle changes direction.
• Some compass headings are not dis-
played.
• The compass headings are inaccurate
in long distance driving.
If the vehicle's compass headings
become inaccurate continuously, the
compass should be manually calibrated
as follows:
1. For optimum calibration, switch off all
nonessential electrical accessories
(rear window defroster, climate control
system, audio system and windshield
wiper, etc.) and close all doors.
2. Move the vehicle to a safe and large
place away from any large steel struc-
tures or power generating cables or
equipment.
3. Turn on the compass function, and
press and hold the COMPASS button
(2) for about 3 seconds until the
"ZONE" appears in the display.
Release the button and the zone num-
ber will appear in the display.
Features of your vehicle
If the zone number is different for your
current location, set the correct zone
number referring to "Setting the compass
zone" and perform the "Calibration pro-
cedure" again.
OEN046035
4 43