Yamaha Motif DDK-7 Owner's Manual page 55

ROTARY SPEAKER
This popular effect (used mainly for electronic organ
sounds) recreates the rich, animated pulsing sound of
a rotating speaker horn.
Effect Type Effect Type
XG ROTARY SP DUAL ROTSP 2
ROTARY SP 1 DIST+ROT SP
ROTARY SP 2 ODRV+ROT SP
ROTARY SP 3 AMP+ROT SP
ROTARY SP 4 DIST+2ROT SP
ROTARY SP 5 ODRV+2ROT SP
2WAY ROT SP AMP+2ROT SP
DUAL ROTSP 1
Parameter Value
EQ Low Freq. 32 - 2.0k Hz
EQ Low Gain -12 - +12 dB
EQ Middle 100 - 16k Hz
Freq.
EQ Middle -12 - +12 dB
Gain
EQ Hi.Freq. 500 - 16k Hz
EQ Hi.Gain -12 - +12 dB
Low/High L63>H - L<H63
Balance
MIC L-R Angle 0 - 180deg
Dist. Drive 0 - 127
Amp. Type Off, Stack, Combo,
Tube
Drive 0 - 127
Description
Determines the central
frequency of the low
frequency range that is
boosted or cut.
Determines the amount over
which the low frequency
range is boosted or cut.
Determines the central
frequency of the middle
frequency range that is
boosted or cut.
Determines the amount over
which the middle frequency
range is boosted or cut.
Determines the central
frequency of the high
frequency range that is
boosted or cut.
Determines the amount over
which the high frequency
range is boosted or cut.
Determines the volume
balance between low and
high speakers.
Determines the L/R angle of
the apparent microphone.
Determines the depth of
distortion. The higher the
value the greater the amount
of distortion.
Determines the amplifier type
simulated.
Determines the amount of
distortion.
DISTORTION
This effect adds distortion to the sound.
Effect Type Effect Type
DIST HARD 1 V_DIST HARD
DIST HARD 2 V_DIST SOFT
DIST SOFT 1 COMP+DIST
DIST SOFT 2 XG CMP+DIST
ST DIST HARD AMP SIM
ST DIST SOFT XG AMP SIM
OVERDRIVE ST AMP SIM 1
ST OVERDRIVE ST AMP SIM 2
XG DIST XG ST AMP
XG ST DIST
Parameter Value
Drive 0 - 127
Amp. Type Off, Stack, Combo,
Tube
LPF Cutoff 1.0 - 18kHz, Thru
OutputLevel 0 - 127
EQ Low Gain -12 - +12 dB
EQ Middle -12 - +12 dB
Gain
Overdrive 0 - 100 %
Device Transistor, Vintage,
Dist 1, Dist 2, Fuzz
Speaker Flat, Stack, Combo,
Twin, Radio,
Megaphone
Presence 0 - 20
Comp. -48 - -6 db
Threshold
Dry/Wet D63>W - D<W63
Description
Determines the amount or
degree of distortion in the
sound.
Determines the type of
amplifier that is simulated.
Determines the cutoff
frequency of the low pass
filter. Frequencies above this
value are cut or filtered out.
Determines the level or
volume of the processed
sound.
Determines the amount of EQ
boost or cut in the low
frequency range.
Determines the amount of EQ
boost or cut in the mid
frequency range.
Determines the depth of
overdrive. The higher the
value the greater the amount
of distortion.
Determines the device that
will create distortion:
Transistor, VintageTube,
Distortion, Fuzz and so on.
Determines the simulated
speaker type: Flat, Stack,
Combo, Twin, Radio,
Megaphone and so on.
Values in the higher range
can give vocals more
presence.
Determines the input level at
which compression begins to
be applied.
Determines the balance of
the original sound and the
effect sound.
DDK-7 Owner's Manual 55
4