PRE (Pre-fader) switches
These switches are used to select pre- or post-fader for signals sent from the stereo input
channel to MIX buses 5–10. Each switch is effective for one pair of MIX buses:5/6, 7/8, or 9/10.
When you turn these switches on, the pre-fader signals are sent to the corresponding MIX bus
BAL (Balance) control
This control is used to adjust the left and right balance of signals sent from the stereo input
channel to the ST bus.
ST (Stereo) switch
When you turn this switch on, the stereo input channel signals will be sent to the ST bus. If you
connect monaural signals to the 13L (MONO) jack or 15L (MONO) jack (see page 17, rear
), the same signals will be sent to both L and R channels.
This switch is used to turn on and off the corresponding stereo input channel. When this switch
is turned off, no signals are sent to the ST bus and MIX buses 1–10. However, using the PFL
will enable you to monitor the signals via the C-R MONITOR OUT jacks or
PFL (Pre-fader listen) switch
When you turn this switch on, the pre-fader signals of the stereo input channel are routed to
the PFL bus, and you can monitor the signals via the C-R MONITOR OUT jacks or PHONES
This fader is used to adjust the level of the stereo input channel signals. This fader setting affects
the level of the signals routed to the ST bus, MIX buses 1–4, and MIX buses 5–8 (when the PRE
switches are turned off).
Signal ﬂow of the stereo input channel
Stereo input channels
1 2 3 4
MC32/12, MC24/12—Owner's Manual