These switches are used to turn on and off the signals routed from the input channel to MIX
Note: When these switches are set to off, no signals will be sent from the input channel to
the corresponding MIX buses regardless of the setting of the switches in the Variable/Fix
select section (see page 6).
M5–M10 mix level controls
These controls route the input channel signals to MIX buses 5–10. Use the PRE switches
select pre- or post-fader.
These switches are used to select pre- or post-fader for signals sent from the input channel to
MIX buses 5–10. Each switch is effective for one pair of MIX buses: 5/6, 7/8, or 9/10. When you
turn these switches on, the pre-fader signals will be sent to the corresponding MIX bus pair.
This control is used to set the stereo image of signals sent from the input channel to the ST
ST (Stereo) switch
When you turn this switch on, input channel signals are sent to the ST buses.
This switch is used to turn on and off the corresponding input channel module. When this
switch is turned off, no signals are sent from the corresponding input channel to the ST buses
and MIX buses 1–10. However, using the PFL switch
via the C-R MONITOR OUT jacks or PHONES jack.
PFL (Pre-fader Listen) switch
When you turn this switch on, the pre-fader signals of the input channel are routed to the PFL
bus, and you are able to monitor the signals via the C-R MONITOR OUT jacks or PHONES
This fader is used to adjust the level of the input channel signals. This fader setting affects the
level of the signals routed to the ST buses, MIX buses 1–4, and MIX buses 5–8 (when the PRE
switches are turned off).
Signal ﬂow of the monaural input channel
Monaural input channels
will enable you to monitor the signals
MC32/12, MC24/12—Owner's Manual
1 2 3 4