Table of Contents
Advertisement
using your iron
Ironing without steam
If you intend to dry iron fabrics, there is no need to fill the water tank. However, if water is
already in the water tank, you do not need to empty it.
1.
Set the steam control to the no steam position (
2.
Plug your iron into the mains supply and switch on.
3.
Select the desired fabric setting using the temperature increase/decrease buttons
(+ or –).
4.
Your iron will begin to heat up and the temperature indicator icon will flash.
5.
When your iron beeps once and the temperature indicator icon stops flashing your
iron is ready to use.
Steam ironing
During steam ironing, if you do not allow the iron to reach the selected
temperature, water may drip from the soleplate.
It is recommended that for harder to iron fabrics such as cotton and linen, steam should
be used when ironing. Steam should never be used on delicate fabrics like nylons,
acrylics and synthetics.
1.
Fill your iron with water.
2.
Plug your iron into the mains supply and switch on.
3.
Select the desired fabric setting using the temperature increase/decrease buttons
(+ or –). For steam ironing, the fabric setting must be either WOOL, COTTON,
DENIM or LINEN. If you select any other fabric type, your iron will not produce
steam.
Note: When the iron is in the steam range, the steam range icon will appear on
the display. There are two steam icons depending on which fabric setting has been
selected. The WOOL and COTTON fabric settings produce less volume of steam
than the DENIM and LINEN settings.
4.
Your iron will begin to heat up and the temperature indicator icon will flash.
5.
When your iron beeps once and the temperature indicator icon stops flashing your
iron is ready to use.
6.
Adjust the steam control for the desired steam output.
7.
Move the steam control lever towards the maximum steam position (
the amount of steam, or towards the no steam position (
of steam.
8.
The iron will automatically begin to steam as soon as the iron is used.
9.
The steam can be shut off at any time by setting the steam control to the no steam
position (
).
).
) to decrease the amount
) to increase
Advertisement
Table of Contents
