Siemens Acvatix SAS Series Basic Documentation page 26

LED Farben und
Blinkmuster
Reset actuator with
pushbutton
Enter address using
pushbutton
Enter new address
(starting from the lowest
address position)
Enter new address
(starting from lowest
address position)
26 / 60
Siemens
Smart Infrastructure
Color Blinking pattern
Green 1s On / 5s Off
Flickering
Orange / green 1s orange / 1s green
Orange 1s On / 1s Off
1s On / 5s Off
Red Permanently lit
1s On / 5s Off
0.1s On / 1s Off
Blue Flickering once after address indication
1. Press button >10s à LED blinking
2. Release button while blinking à LED blinking for another 3s
3. Reset is interrupted if the pushbutton is pressed during the 3s
4. After 3s, à LED is lit
The Modbus address can be set without extra tool by means of pushbutton
addressing.
To display the current Modbus address, press the button <1s.
Colors
1st digit: red
Example for address 124:
LED
The address is entered and displayed beginning at the lowest digit (1st digit), see
figure above.
Note
(Example: 124 starts with 4x red)
1. Enable addressing mode: Press button > 1s until the LED is red, then release
button (before LED goes off).
2. Enter the numbers: Push button n-times à LED blinks each time the button is
pressed as a feedback.
Colors: 1st digit: red
3. Save digits: Press button until LED is lit in the color of the next digit, then
release the button,
4. Save address: Press button until LED is
button.
An address can be saved any time, i.e., after entering the 1st digit or after
entering the1st digit and 2nd digit.
5. The entered address is displayed again 1x for confirmation.
Note: Address entry is interrupted when the button is released before the LED is
red, address entry is interrupted.
Actuators SAS.., SAT.. for valves
Handling
orange
red (reset) while the device restarts.
2nd digit: green
/ 2nd digit: green / 3rd digit:
red
Description
Normal mode without bus traffic
Normal mode with bus traffic
Device is in override control mode
Bus parameter not yet configured
Device is in backup mode (replacement
mode)
Mechanical error, device blocked, manual
intervention or calibration
Internal error
Invalid configuration, e.g. Min = Max
Bus termination active
3rd digit:
orange
(confirmation) à, then release
orange
CE1P4041en
2019-04-09