Subscribe to Our Youtube Channel
Related Manuals for Global Fire Equipment JUNIOR MINI-REP
Summary of Contents for Global Fire Equipment JUNIOR MINI-REP
- Page 1 Manufacturers of Fire Detection Equipment JUNIOR MINI-REP INSTALLATION MANUAL 1.0 - 12/2015 JUNIOR MINI-REP JUNIOR MINI REPEATER PANEL INSTALLATION MANUAL version 1.0 - 12/2015 globalfire.pt...
- Page 2 INSTALLATION MANUAL 1.0 - 12/2015 OVERVIEW The JUNIOR MINI-REP is a fully functional mini version of the JUNO NET Repeater which can be used with any distributed or self contained JUNO NET or JUNIOR based Fire Alarm system. Its reduced dimensions make it ideal for installation in reception areas or security booths where it would be impractical and unattractive to install a full size control panel.
-
Page 3: Important Notes
MINI-REP is going to be networked with either of these panel models, a modified overlay can optionally be provided in these occasions. Please contact GFE for details. Optionally the JUNIOR MINI-REP can be provided with a key-switch in order to gain access to Aceess Level 2 (Authorised User). Please contact GFE for details. -
Page 4: Installation
Manufacturers of Fire Detection Equipment JUNIOR MINI-REP INSTALLATION MANUAL 1.0 - 12/2015 INSTALLATION In order to correctly install a JUNIOR MINI-REP the following steps should be taken: a) Remove the 4 screws fixing JUNIOR MINI-REP display to the unit’s back box. -
Page 5: Mechanical Details
SYSTEM FAULT LAMP TEST DETECTORS SOUNDERS DELAYS ACTIVATE/ SILENCE ACTIVE 256 mm 75 mm Top Cable Entry Rear Cable Entry Data Loop Interface PCB - Stand-offs Back Box - Mounting Holes 246 mm Figure 1: JUNIOR MINI-REP - Mechanical information globalfire.pt... - Page 6 INTERFACE FOR TCP/IP COMMUNICATION VIEW FROM FRONT NOTE: THROUGHOUT THE MANUAL, MALE FEMALE PIN ON THE 5 WAY MOLEX INDICATES WHICH PIN IS Nº1 Typical cable form (one end) VIEW FROM TOP Figure 2: JUNIOR MINI-REP - Network Interfaces globalfire.pt...
- Page 7 Connect JUNIOR MINI-REP CON3 (Data Loop) to corresponding interface using the 5-way flat cable provided with each interface. DATA LOOP +24 V DC Ground ( 0V ) Earth Figure 3: JUNIOR MINI-REP - General Hardware and Connections Layout for RS-422/485 connection globalfire.pt...
- Page 8 REP on JUNIOR V4 and to CON3 or JUNIOR version 2 main board. JUNIOR MINI-REP RS-485 OUT RS-485 IN Rx1 a Tx1 a Tx1 b Rx1 b Tx2 a Rx2 a Tx2 b Rx2 b Figure 4: JUNIOR MINI-REP - RS-485 Data Loop Connections globalfire.pt...
- Page 9 NOTES: On JUNIOR Panel interface DIL Switches 1 & 2 should be removed. On JUNIOR MINI-REP interface DIL Switches 1 & 2 should be ON. Interface CON3 should be connected to DATA CON on JUNIOR version 3 panel, to MINI-REP on JUNIOR V4 and to CON3 or JUNIOR version 2 main board.
- Page 10 DATA LOOP (CON 3) on JUNIOR MINI-REP. SUB-PANEL RS-485 OUT RS-485 IN Tx1 a Rx1 a Tx1 b Rx1 b Tx2 a Rx2 a Tx2 b Rx2 b Figure 6: JUNO NET Panel - JUNIOR MINI-REP SUB-PANEL - RS-485 Data Loop Connections globalfire.pt...
-
Page 11: Operation
Manufacturers of Fire Detection Equipment JUNIOR MINI-REP INSTALLATION MANUAL 1.0 - 12/2015 OPERATION QUEUE REVIEW STATUS ZONES FIRE FIRE FAULT PRE-ALARM FAULT TEST TEST DISABLED SYSTEM ON DISABLED FAULTS KEYPAD CONTROLS DISABLEMENTS BUZZER AUXILIARY ALARM FAULT SILENCE RELAYS SOUNDERS SUPPLY FAULT... - Page 12 Manufacturers of Fire Detection Equipment JUNIOR MINI-REP INSTALLATION MANUAL 1.0 - 12/2015 CONTROLS BUZZER SILENCE: Pressing this button will silence the internal buzzer during a new FIRE condition as well as during a new FAULT condition. BUZZER SILENCE: If the LED is lit it indicates that a new FIRE or FAULT condition is present on the system.
-
Page 13: Troubleshooting
Verify using a voltmeter that the supply voltage is 24V DC. The green LED is ON but the LCD shows message “NO COMS TO MAIN PANEL” This fault is normally associated with a communication fault between the Main Panel and JUNIOR MINI-REP(s). Press the SILENCE BUZZER button. - Page 14 JUNIOR MINI-REP INSTALLATION MANUAL 1.0 - 12/2015 GLOBAL FIRE EQUIPMENT S.A. Sítio dos Barrabés, Armazém Nave Y, Caixa Postal 908-Z, 8150-016 São Brás de Alportel - PORTUGAL Tel: +351 289 896 560 • Sales: sales@globalfire.pt • Technical Support: techs@globalfire.pt • www.globalfire.pt...
Need help?
Do you have a question about the JUNIOR MINI-REP and is the answer not in the manual?
Questions and answers