Table of Contents
Advertisement
If faults or causes of faults are not listed below, have them rectified by
the responsible dealer.
Fault
Machine does not drive.
Machine only runs slowly and not
at full power.
Overheating.
Noises.
Noises.
*) Have this work carried out by the responsible dealer.
TRANSMISSION
Fault cause
Parking brake on
Drive direction lever not engaged
correctly
Oil level too low
Oil level too low
Oil level too low or too high
Machine being driven in a gear
which is too high
Engine overheating
Oil level too low
AXLES
Oil level too low
Incorrect oil for machine with
multi-disc self-locking differential
Troubleshooting
Remedy
Release parking brake.
Engage drive direction lever
correctly.
Top up with oil according to
specifications.
Top up with oil according to
specifications.
Top up with oil according to
specifications.
Run machine in a lower gear.
See "ENGINE; fault: Temperature
gauge in red zone and respective
control lamp flashing."
Top up with oil according to
specifications.
Top up with oil according to
specifications.
Top up with specified oil.
2 - 69
Advertisement
Table of Contents
