Yamaha Clavinova CVP-208 Owner's Manual page 165

7
Installing the pedal box.
1 Remove the plastic cover
from the rear legs.
4 Make sure that the pedal box lays flat, with no gap
between itself and the floor, then affix the pedal box
using two screws.
8
Connect the pedal cord.
9
Installing the speaker cover to the speaker box.
Install the speaker cover on
the speaker box so that the
dented side comes to the
upper-right corner.
Align two plugs on the
speaker cover with the holes
on the speaker box, and
push in where the velcro
tape strips are attached.
CAUTION
The speaker cover is made of a very soft material. Pushing
in a place where no tab or velcro tape is located may dam-
age the speakers.
2 Untie and straighten out the
bundled cord attached to the
bottom of the pedal box.
3 Pass the pedal cord
between the pedal box
and the rear leg.
1 Insert the pedal
cord plug into the
pedal connector.
Insert the plug
with the arrow-
printed side fac-
ing front (toward
the keyboard side).
If the plug will not go in easily,
do not force it. Double-check the
orientation of the plug, then try
again.
2 Align the pedal cord into the
groove on the rear leg, and
install the plastic cover onto
the groove. Be careful not to
insert the cover's attachment
strip between the groove wall
and the leg.
CVP-210/208: Keyboard Stand Assembly
10
Set the voltage selector and connect the power cord.
240
127
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the selector
for 110V, 127V, 220V or 240V main voltages, use a "minus"
screwdriver to rotate the selector dial so that the correct voltage for
your region appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially shipped.
After the proper voltage has been selected, connect the AC power
cord to the AC INLET and an AC wall outlet. A plug adaptor may be
also provided in some areas to match the pin configuration of the AC
wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the
Clavinova or result in improper operation.
■ After completing the assembly, please
check the following.
• Are there any parts left over?
→
Review the assembly procedure and correct any
errors.
• Is the Clavinova clear of doors and other movable
fixtures?
→
Move the Clavinova to an appropriate location.
• Does the Clavinova make a rattling noise when
you shake it?
→
Tighten all screws.
• Are the pedal and power cords inserted securely
into the sockets?
→
Check the connection.
• If the main unit creaks or is otherwise unsteady
when you play on the keyboard, refer to the
assembly diagrams and retighten all screws.
When moving the instrument after assembly, always
hold the bottom of the main unit.
CAUTION
Do not hold the key cover or top portion. Improper handling
can result in damage to the instrument or personal injury.
Key cover
If you move the instrument after assembly, affix the screws on
the pedal box again so that the pedal box will lay flat, with no gap
between itself and the floor. (See step 7-4.)
(the bottom of the right side
as seen from the front)
Top portion
CVP-210/208 165