Effect Structure - Yamaha Clavinova CVP-208 Owner's Manual

Effect Structure

The CVP-210/208 features the following digital effect systems, which can be applied independently for the Natural
voices (page 92) and the Regular voices (page 92). The effect type, depth, and various parameters can be set with the
panel controls.
About the Effect Connections — System and Insertion
All the effect blocks are connected or routed in one of two ways: System or Insertion. System applies the selected effect
to all parts, while Insertion applies the selected effect to one specific part. Reverb, Chorus and DSP 2 are System effects,
and DSP 3 - 7 (CVP-210)/DSP 3 - 5 (CVP-208) are Insertion effects. The DSP 1 effect, on the other hand, can be
configured for either System or Insertion routing.
The illustration below shows how the various effect blocks are set up and traces the signal flow for the send/return
controls set on the CVP-210/208.
For Regular Voices (CVP-210)
Unused DSP blocks are automatically
assigned to the active parts.
MAIN VOICE
LAYER VOICE
LEFT VOICE
SONG
(each channel)
MIC. Effect
MIC
3 Band Noise
Compressor
EQ Gate
STYLE
(each channel)
When DSP is set as an Insertion effect
(here PART is set to one of the
STYLE channels), it is put here
Adjust the Volume Balance and Changing Voices — Mixing Console
Dry
DSP3
Rev Send
Cho Send
Dry
DSP4
Rev Send
Cho Send
Dry
DSP5
Rev Send
Cho Send
Dry
DSP6
Rev Send
Cho Send
Dry
Vocal
Rev Send
DSP7
Harmony
Cho Send
Dry
DSP1
Rev Send
Cho Send
DSP Send
in the signal flow.
DRY LINE
REVERB1
CHORUS1
When DSP is set as a System effect,
it is put here in the signal flow.
DSP1
Master EQ OUT
CVP-210/208 129