Working On The Device; Service Notes - Laserworld Ecoline Series Manual

Manual: Ecoline Series EL-250RGB Micro
11. Never use dimmer, RC or other electroni-
cally switched sockets. Whenever possib-
le, do not use the laser projector together
with large appliances (especially fog ma-
chines) on the same mains!
12. Ensure sufficient ventilation and do not
place the device on any warm or heat ra-
diating surface. Especially the ventilati-

4. Working on the Device

1. Be sure that the mains plug is not connected to the power sup-
ply while installing or opening the device (e.g. for cleaning).
2. Take off all reflecting things like rings, watches etc. before
start working with or at the projector.
3. Use only non-reflecting tools to work on device.
4. Wear protective clothing (like goggles, gloves etc.) accor-
ding to laser power and wavelength of the laser.

5. Service Notes

• Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of device can re-
duce durability of the laser diode drama-
tically.
• Avoid concussions during transport.
• To increase durability of your laser, please
protect device against overheating:
-
Always ensure sufficient ventilation.
-
Do not address spotlights (especially
moving heads) on the device.
-
Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
-
Keep the device dry. Protect it from
page 5 / 15
on openings must not be covered!
13. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
moisture, rain and damp.
-
Switch off device when it is not nee-
ded. Diodes are switched on and can
wear off even if there is no visible la-
ser output.
• Open the device at regular intervals and
remove any dust build up, particularly
around fans and laser. Otherwise the risk
of overheating is imminent and will void
the warranty.
• Should you find traces of fog fluid, clean
the device and change position of it or of
the fog machine.
• The devices of Ecoline, Evolution and
Club-Series are not suitable for conti-
nuous operation. After approx. one hour