Working On The Device; Service Notes - Laserworld 7640144992217 Manual

Manual: Ecoline Series EL-500RGB KeyTEX
11. Ensure that device does not get over-
heated. Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.

4. Working on the device

1. Be sure that the mains plug is not connected to the power supply
while installing.
2. Take off all reflecting things like rings, watches etc. before
starting to work with or at the projector.
3. Only use non-reflecting tools to work on device.
4. Wear protective clothing (like goggles, gloves etc.)
according to laser power and wavelength of the laser.

5. Service notes

• Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of this device will
reduce durability of the laser source dra-
matically.
• Avoid sharp knocks and shocks to this
device and ensure sufficient protection
during transportation. Look after your La-
serworld product.
• To increase durability of your laser,
protect device against overheating:
-
Always ensure sufficient ventilation.
-
Do not face spotlights (especially mo-
ving heads) to the device.
-
Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
-
Keep the device dry. Protect it from
moisture, rain and damp.
page 5 / 33
12. This unit is intended for indoor use only.
-
Switch off device when it is not nee-
ded. Laser sources are switched on
and can wear out even if there is no
visible laser output.
• The devices of Ecoline, Evolution, Club
and Proline Series are not meant for pro-
fessional applications. After approx. one
hour of operation, the device should cool
down for about 15 minutes.
• Please ensure the fans and heatsinks are
clear from dust and debris otherwise the
risk of overheating may occur. If the unit
and airways appear to be blocked then
please contact a qualified service engi-
neer to maintain and service the product.
• Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.