Connect Camera; Insert Micro Sd Card; Operation; A) Basic Functions - VOLTCRAFT BS-300XRSD Operating Instructions Manual

11. CONNECT CAMERA

• Connect the plug of the gooseneck camera to the connector socket on the monitor. At the
same time the protruding metal tongue on the plug of the camera should be aligned to the
slot at the front of the socket.
• Push the screw cap upwards in the direction of the camera and turn the screw cap
anticlockwise to attach the camera.
• Reverse these steps to disconnect the camera from the main unit.

12. INSERT MICRO SD CARD

You must first insert a microSD card (not included) to be able to use the photo /video function.
Proceed as follows to do so:
• Open the cover on the right next to the monitor.
• Insert a microSD card into the microSD slot (13). The contacts of the card must point in the
direction of the monitor. The card must be locked into position.
• Close the cover.

13. OPERATION

a) Basic functions

Only keep the camera head and goose neck (1) in voltage free liquid. The goose neck
should not be immersed on the other side of the "IP67 max. water level" marking.
The endoscope is suited for inspection only in voltage-free systems. The camera
head is made of metal and can cause short-circuiting. For safety reasons, make sure
all system components are voltage-free before inspection.
Avoid heavy mechanical loads and/or vibrations. Do not exceed the minimum
bending radius of 45 mm.
• Press the on/off button (11) to switch on the device. The Power LED (3) is switched on. Then
scroll the brightness control (6) in the "ON" direction. The camera picture appears on the screen.
• Four LEDs are integrated into the camera head.
• Adjust the brightness control in the "ON" direction to increase the brightness of the LEDs.
29