Notes On (Rechargeable) Batteries; A) General; B) Li-Po Battery - VOLTCRAFT BS-300XRSD Operating Instructions Manual

Endoscope wireless
Table of Contents

Advertisement

Available languages

Available languages

7. NOTES ON (RECHARGEABLE) BATTERIES

a) General

• Correct polarity must be observed while inserting the (rechargeable) batteries.
• Rechargeable batteries should be removed from the device if it is not used for a long period
of time to avoid damage through leaking. Leaking or damaged (rechargeable) batteries
might cause acid burns when in contact with skin, Therefore use suitable protective gloves
to handle corrupted (rechargeable) batteries.
• (Rechargeable) batteries must be kept out of reach of children. Do not leave (rechargeable)
batteries lying around, as there is risk, that children or pets swallow them.
• All (rechargeable) batteries should be replaced at the same time. Mixing old and new
(rechargeable) batteries in the device can lead to (rechargeable) battery leakage and device
damage.
• (Rechargeable) batteries must not be dismantled, short-circuited or thrown into fire. Never
recharge non-rechargeable batteries. There is a risk of explosion!

b) Li-Po battery

• The rechargeable battery is permanently built into the product and cannot be replaced.
• Never damage the rechargeable battery. Damaging the casing of the rechargeable battery
might cause an explosion or a fire! Unlike conventional batteries/rechargeable batteries (e.g.
AA or AAA type), the casing of the LiPo rechargeable battery does not consist of a thin sheet
but rather a sensitive plastic film only.
• Never short-circuit the contacts of the rechargeable battery. Do not throw the rechargeable
battery or the product into fire. There is a danger of fire and explosion!
• Charge the rechargeable battery regularly, even if you are not using the product. Due to the
rechargeable battery technology being used, you do not need to discharge the rechargeable
battery first.
• Never charge the rechargeable battery of the product unattended.
• When charging, place the product on a surface that is not heat-sensitive. It is normal that a
certain amount of heat is generated during charging.
26

Advertisement

Table of Contents
loading

This manual is also suitable for:

4016138910780

Table of Contents