Section 3-Maintenance; Installing/Removing The Back Cushion - Invacare InTouch PCS ITPCSR Owner's Operator And Maintenance Manual

SECTION 3—MAINTENANCE
SECTION 3—MAINTENANCE

Installing/Removing the Back Cushion

NOTE: For this procedure, refer to FIGURE 3.1.
NOTE: To remove the back cushion, reverse this procedure.
1. Separate the hook and loop material at the bottom of the back cushion and flip the large upholstery flap up and
away from the back cushion.
2. Put the back cushion face down on a flat, stable surface.
3. Put the back face down onto the back cushion.
4. Put the top of the back shell into the pocket at the top of the back cushion.
5. Pull the bottom upholstery flap around the bottom of the back and fasten the hook material on the inside of the
bottom upholstery flap (C) to the loop material on the bottom of the back shell (D).
6. Fasten the hook material on the large upholstery flap (A) to the loop material on the bottom upholstery flap (B).
NOTE: There are two strips of hook material on the back shell that hold the back cushion in place.
7. Flip the back over and apply slight pressure to the back cushion to fasten the back cushion to the back shell.
Rear View of Back Cushion
TOP
Outside Loop material (B) fastens to (A)
BOTTOM
Rear view of the Back Shell
TOP
BOTTOM
™ ™
InTouch PCS Positioning Back
Large Upholstery Flap
Back shell
FIGURE 3.1 Installing/Removing the Back Cushion
Hook Material (A) fastens to (B)
Opening in upholstery
for head rest mounting
12
Pocket in Upholstery
Inside loop material (C)
fastens to (D)
Hook material (D)
fastens to (C)
Part No 1163138