Continuous Drainage - Xpelair XPCDH10 Instruction Manual

Drainage
While the water tank is full, the compressor will stop for self-protection and the water tank full indicator light
will turn red.
To move the water tank, pull it out squarely from the unit.
After emptying the water tank, place the water tank carefully back into its location into space. The tank must
be properly located in order for the 'water full' light to go out and for your dehumidifier to start operating again.
Please note, if the water tank has not been positioned/located correctly, the water full indicator will stay red
and the product will not operate.

CONTINUOUS DRAINAGE

When the dehumidifier is operated at very high humidity levels, the water tank will require more frequent
emptying. In this situation, it may be more convenient to set the unit up for continuous drainage, this can
be done as follows:
1. Pull out the water tank.
2. Connect a water drain tube of inner
diameter 11 mm to the drain spout
connection outlet at the top of the
tank location area.
* Please note, the water tube is not supplied
with the unit.
3. Ensure the drain tube is fixed properly
and that water will always drain away
freely through the tube (the drain point/open
end of the tube must be at a lower height than
the drain outlet from the product).
Note! In very cold weather conditions,
precautions should be taken to prevent the
water tube from freezing.
4. Put the water tank back to its position.
Spout connection
for continuous
drainage
Water drain tube
with 11mm internal
diameter
11