Keyboard Stand Assembly - Yamaha Clavinova CLP-220 Owner's Manual

Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to
install all parts in the correct direction. Please
assemble in accordance with the sequence given
below.
• Assembly should be carried out by at least two per-
sons.
• Be sure to use the included screws only, and insert
screws of the correct size in the correct hole loca-
tions. Do not use any other screws. Use of incorrect
screws can cause damage or malfunction of the
product.
• Be sure to tighten up all screws upon completing
assembly of each unit.
• To disassemble, reverse the assembly sequence
given below.
Have a Phillips-head (+) screwdriver ready
Remove all parts from the package and make sure you
have all of the items.
D
Bundled pedal
cord inside
Assembly Parts
6 × 20 mm long screws ×4
6 × 16 mm short screws ×4
4 × 12 mm thin screws ×2
Headphone hanger set
4 × 10 mm thin screws ×2
34

Keyboard Stand Assembly

CLP-220
A
E
B
C
AC power cord
1 4 × 20 mm tapping screws ×4
4
2 Cord holders × 2
Side panel protection
3
(cardboard) pads × 2
5
Headphone hanger
1.
Attach (finger-tighten) C to D and E.
1-1 Untie and straighten out the bundled pedal
cord. Don't discard the vinyl tie. You will
need it later in step 6.
1-2 Align D and E with each end of C.
1-3 Attach D and E to C by finger-tightening the
long screws 1 (6 × 20mm).
1-2
E
C
1-3
2.
Attach B.
Depending on the model of Clavinova you purchased,
the surface color of one side of B may be different from
the other side. In this case, position B so that the side
of the surface color similar to D and E faces the player.
2-1 Place the lower side of B on each foot of D
and E, then attach the upper side to D and E.
2-2 Attach the top of B to D and E by finger-
tightening the thin screws 3 (4 × 12mm).
2-3 While pushing the lower part of D and E
from outside, secure the bottom ends of B
using two tapping screws 4 (4 × 20mm).
2-4 Insert the other two tapping screws 4 (4 ×
20mm) into the other two screw holes to secure
B.
E
2-1
Place the bottom
ends of the rear
panel on each foot.
2-3
2-4
D
1-1
2-2
B
D
2-3