Threading The Upper Looper (Red) - Necchi L234A Instruction Manual

1
1
4
3
2
v Threading the upper looper (red)
When threading the upper looper, follow the
1
thread path marked with a red dot.
Open the front cover. Raise the needle to
highest position by turning the hand wheel
toward you. Raise the presser foot. Pass the
thread from back to front through the thread
guide on the thread stand. Use the tweezers
to make the threading easier.
Telescopic thread stand
1
Pull the thread from right to left under the
upper thread guide.
Upper thread guide
1
While holding the thread with both hands,
pass it between the tension discs and pull
it down to make certain it is properly placed
between the tension discs.
Tension discs
1
Thread the looper area of the machine
following the red color coded thread guides.
Use the tweezers to make the threading
easier.
Use the tweezers to bring the thread behind
the lower looper and thread into the hole in
the upper looper from front to back.
1
Pull about 10cm (4") of thread through the
looper and place it to the back of the stitch
plate.
-
1 3
Upper looper hole
4
11
Thread guides