Table of Contents
Advertisement
FORCE OUTPUT ON/OFF (MANUAL OVER-RIDE)
The following example uses two contacts to implement manual over-ride. X10 is used as a selector
switch, if it is OFF then manual over-ride is disabled if it is ON then manual over-ride is enabled. If X10
is ON then X11 selects which state to force the output, X11 OFF forces the output OFF, X11 ON forces
the output ON. You can change the X and C references to whatever best meets your application needs.
If your loop does not start at V5000 then you need to change the V-Memory reference accordingly.
SUPPORTING LADDER LOGIC
3.3
Advertisement
Table of Contents
