Control Panel - LG SIGNATURE WM9500H A Series Owner's Manual

Control Panel

1
STEAM CYCLE
Normal
Heavy Duty
Bedding
Perm.Press
Towels
General
Control Panel Features
Power On/Off Button
1
Press to turn the washer on. Press again to
turn the washer off. Pressing the Power button
during a cycle will cancel that cycle and any load
settings will be lost. The door will unlock after a
brief pause.
Start/Pause Button
2
Press this button to start the selected cycle. If the
washer is running, use this button to pause the
cycle without losing the current settings.
NOTE
• If Start/Pause is not pressed within 60 minutes
of selecting a cycle, the washer automatically
turns off and all cycle settings are lost.
Cycle Modifier Buttons
3
Use these buttons to adjust the water
temperature, spin speed and soil level settings
for the selected cycle. The current settings are
shown in the display. Press the button for that
option to select other settings.
Special Cycle and Option Buttons
4
These buttons allow you to select special cycles
or additional cycle options. Certain buttons
also allow you to activate special functions
by pressing and holding the button for three
seconds.
Time and Status Display
5
The display shows the settings, estimated time
remaining, options, and status messages for
your washer. When the washer is turned on, the
default settings in the display will illuminate.
Sanitary Delicates
Allergiene Sportswear
TM
Bright Whites Speed Wash
TM
Tub Clean Rinse+Spin
Jumbo Wash Downloaded
Caring Special
2
Steam Sensing Wash Rinse Spin
* Fresh Care
Extra Hot Extra High
Smart Grid
Hot High
* Remote Start
Warm Medium
Delay Wash
Cold Low
* Wi-Fi Connect
Hold to Start Tap Cold No Spin
Add Garments
Temp. Spin
All Cold Rinses
3
4
Door Lock Indicator
The Door Lock indicator will light up once a cycle has
started. The indicator light will stay on until the cycle
is paused, stopped or has finished.
Child Lock Indicator
When the Child Lock function is activated, a
message and the remaining wash time are displayed,
in turn, on the display panel of the washer. When the
Child Lock function is set, all controls are disabled
except for the Power button.
Cycle Status Indicator
These LEDs will illuminate when a cycle is selected
to indicate which stages will run. When a cycle is
running, the LED for the active stage will blink, and
the LEDs for the remaining stages will remain steady.
Once a stage is complete, the LED will turn off. If
a cycle is paused, the active stage LED will stop
blinking.
Estimated Time Remaining
When a cycle is selected, the default time for that
cycle is displayed,. This time will change as modifi
ers or options are selected. Once the Start/Pause
button is pressed, the washer will measure the size
of the load. The estimated time may change once the
load size has been measured. If Delay Wash is set,
the remaining delay time counts down until the cycle
begins.
NOTE
• The time shown is only an estimate. This time is
based on normal operating conditions. Several
external factors (load size, room temperature,
incoming water temperature,etc.) can affect the
actual time.
OPERATION
5
Press and hiold 3secs for extra functions
Turbo Wash
TM
Heavy Grid Mode
Cold Wash
Remote
Normal High
Extra Rinse
Low
* Drum Light
Light Off
Pre Wash
Soil Signal
* Child Lock
,
Sensing Wash Rinse Spin
23