Display Messages; Copy Protection (Scms) - Yamaha MDX-E100 Owner's Manual

DISPLAY MESSAGES

Can't copy
Digital recording cannot be performed. (See "COPY
PROTECTION (SCMS)" on this page.)
Can't edit!
Edit operations are not possible.
Can't REC!
Recording is not possible. The loaded disc may be
protected or there may not be enough blank space
remaining on the disc.
Can't REC
Recording is not possible. The loaded disc may be
damaged.
DIG in Unlock
No digital signal is being input to the selected digital
input jack.
TMP Over!!
The temperature of the unit has exceeded the normal
operating temperature. Turn off the unit and let it cool
down. If the unit is installed in a place with little
ventilation (such as a built in bookcase), move the unit
to another location with better ventilation.
Disc Full
Recording is not possible because there is no blank
space remaining on the disc.
Title Full!
Additional characters cannot be input for the current
title because the maximum number of characters for a
single title (250) has already been input.
UTOC W Error
Error occurred when writing to the UTOC.
Not Audio
The inserted disc is not an audio MD.
Tr Protected
The selected track cannot be edited because it is
protected.
TOC Full
The disc area allotted for TOC data has become full and
further editing is not possible.
UTOC Err L0~4
Problem involving UTOC data.
TOC Writing
The TOC data is being written to the disc. Do not move
the unit or pull out the mains lead. If you do, recorded
material may not be saved normally.
TOC Reading
The unit is reading the TOC data.
Protected
The record protection on the inserted MD is set to
"protect".
PlayBack MD
The inserted MD is a designed for playback only (you
cannot record on this disc).
Monitor Out
The monitor out function is active. The audio signal
input to the selected input terminals is output from this
unit's output terminals.
No Track
Blank disc is played or searched.

COPY PROTECTION (SCMS)

As a digital audio component, this MD recorder
conforms with the Serial Copy Management System
(SCMS) standards. The Serial Copy Management
System restricts copies made by recording digital signals
to first-generation copies only. Therefore, an MD
recorded through a digital input cannot be used as a
source for making another digital recording.
Care of MDs
• Do not expose the MD to direct sunlight or heat
sources such as hot air ducts, nor leave it in a car
parked in direct sunlight as there can be a
considerable rise in temperature inside the car.
• Periodically remove dust and debris from the cartridge
surface by wiping it with a dry cloth.
• Because the MD itself is housed in a cartridge, you
can handle it normally without being concerned about
dirt or fingerprints. However, malfunctioning may
result if the cartridge itself is dirty or warped.
Do not open the shutter on the MD cartridge
Trying to force the shutter open will damage the shutter.
E-21