Display Messages - Yamaha MDX-595 Owner's Manual

DISPLAY MESSAGES

Can't Copy
Digital recording cannot be performed. (See "COPY
PROTECTION (SCMS)" on page 26.)
Can't Edit
Edit operations are not possible.
Can't Play!
Timer playback is not possible. The loaded disc may be
blank, damaged, or an incompatible format.
Can't REC!
Timer recording is not possible. The loaded disc may be
protected or there may not be enough blank space
remaining on the disc.
Can't REC
Recording is not possible because there is not enough
blank space remaining on the disc.
DIGin Unlock
No digital signal is being input to the selected digital input
jack.
Disc Full
Recording is not possible because there is no blank space
remaining on the disc.
Program Full
Additional steps cannot be programmed because the
maximum number of steps (30) has already been
programmed.
Title Full
Additional characters cannot be input for the current title
because the maximum number of characters for a single
title (250) has already been input.
UTOC WError
Error occurred when writing to the UTOC.
Not Audio
The inserted disc is not an audio MD.
Tr Protected
The selected track cannot be edited because it is
protected.
TOC Full
The disc area allotted for TOC data has become full and
further editing is not possible.
UTOC ERR L...
Problem involving UTOC data.
28
TMP Over!!
The temperature of the unit has exceeded the normal
operating temperature. Turn off the unit and let it cool
down. If the unit is installed in a place with little ventilation
(such as a built in bookcase), move the unit to another
location with better ventilation.
TOC Writing
The TOC data is being written to the disc. Do not move the
unit or pull out the mains lead. If you do, recorded material
may not be saved normally.
TOC Reading
The unit is reading the TOC data.
Protected
The record protection on the inserted MD is set to
"protect".
Playback MD
The inserted MD is a designed for playback only (you
cannot record on this disc).
MONITOR OUT
The monitor out function is active. The audio signal input to
the selected input terminals is output from this unit's output
terminals.