Panasonic ES-RT84 Manual page 32

►Cleaning the shaver
Remove any soap or water on the shaver if it has been
washed with hand soap or any other detergent.
1
1
Insert the appliance plug into the
self-cleaning recharger.
2
2
Pull up the charging terminal until
it clicks.
3
3
Remove the protective cap and
then attach the shaver.
4
4
Push down the charging terminal
until it clicks.
5
5
Plug in the adaptor into a household outlet.
• Turn the shaver off before attaching.
• Check that the outer foil is not deformed or damaged
when you are attaching the shaver.
6
6
Press the SELECT button to select the mode.
• The "Charge" mode starts when attaching the shaver.
• Each time you press the SELECT button, the mode
changes from "AUTO"
• The modes start approximately 6 seconds after they
are selected.
• The mode will be aborted if the power is cut off. In this
case, perform the mode again from the beginning.
• Do not press the cleaning liquid unit removal button as
the cleaning liquid may spill causing a malfunction.
32
ES-RT84_CH.indb 32
"Charge".
Mode Time required (guide)
Charge
Charge
0 to 60 min
Clean
AUTO
10 min
• It is not possible to change the mode
after the "AUTO" mode has started.
• Use the self-cleaning recharger within the temperature
range of 15 – 35 °C.
• For 0 °C or less (extremely low temperatures), the
self-cleaning recharger CHECK lamp glows for 5
seconds and "AUTO" mode stops.
• For 0 °C or less (extremely low temperatures), the
charge status lamp (red) of the main body blinks
quickly and "Charge" mode stops.
Dry Charge
170 min 0 to 60 min
2013/07/17 14:27:44