Panasonic Nanoe EH-ANA3 Manual page 21

1. Pull on the catch on the bottom side of the fi lter to
detach.
Filter
· Remove the dust etc. adhered to the outside of the
fi lter using a vacuum cleaner. If this does not remove
the dust, use your fi ngers to push the dust etc.
through the fi ne mesh on the internal side towards
the metal mesh on the external side, and scrub
away carefully with a toothbrush.
· Using the toothbrush, carefully scrub away any dust
etc. from the internal side of the fi lter.
· Using a vacuum cleaner or toothbrush, carefully
remove any dust etc. adhered to the air inlet.
* Rubbing forcefully with your nails may tear the
fi lter, so please use a toothbrush.
2. As shown in the illustration, press the fi lter onto the
hair dryer until a click is heard.
Catch
1
2
Maintaining the nanoe™ outlet Maintaining the nanoe™ outlet
If sparks occur inside the nanoe™ outlet, the
electrodes have become dirty resulting in an abnormal
discharge. If this happens, clean the inside of the
nanoe™ outlet as follows.
· Clean only after turning off the power and removing
the power cord from the power outlet.
· A needle portion is located deep within the nanoe™
outlet. Using a dampened cotton swab, rub this
portion gently about fi ve times.
· A thin cotton swab is recommended. A regular
cotton swab may work, but its thick head may be
diffi cult to insert.
· Do not use hard objects to clean, or allow hard
objects to come into contact with, the parts of the
nanoe™ outlet so as to avoid causing them to
become deformed, which would affect the discharge
of nanoe™ and be dangerous.
Gently rub the tip of the needle portion
nanoe™ outlet
cotton swab
21