F3.5: 1St Voice Effect Depth; F3.6: 2Nd Voice Effect Depth; F3.7: Reset; F4 Split Mode Functions - Yamaha P-80 Owner's Manual

F3.5: 1st Voice Effect Depth

F3.6: 2nd Voice Effect Depth

These functions make it possible to individually set the depth of the effect for the 1st and 2nd
dual-mode Voices ("1st" and "2nd" is explained on page 15). Use the [–/NOM] and [+/YESL]
buttons to set the effect depth for the corresponding voice as required. The depth range is from 0
through 20. A setting of "0" produces no effect, while a setting of "20" produces maximum effect
depth. Press the [–/NOM] and [+/YESL] buttons simultaneously to recall the default setting (differ-
ent for each voice combination).

F3.7: Reset

This function resets all dual-mode functions to their default values. Press the [+/YESL] button to
reset the values. "End" will appear on the display when all functions have been reset.
F4
Split Mode Functions
After selecting "F4. Y ", press the [+/YESL] button to engage the split-mode function sub-mode,
then use the [TEMPO/FUNCTION# M,L] buttons to select the desired split mode function, as
listed below.
If the Split mode is not engaged "F4. - " will appear instead of "F4. Y " and the Split mode
functions cannot be selected. Also note that you must exit from the Function mode before the
Split mode can be engaged.
I SHORTCUT: You can jump directly to the split-mode functions (F4) by pressing the

F4.1: Split Point

In addition to the split point setting method described on page 16, the split point can be set via this
function. Use the [–/NOM] and [+/YESL] buttons to set the split point as required, or simply press
the appropriate key on the keyboard: from "A-1" to "C7". Press the [–/NOM] and [+/YESL]
buttons simultaneously to recall the default setting "F#2".

F4.2: Split Balance

The volume levels of the two voices combined in the split mode can be adjusted as required by
using this function. Use the [–/NOM] and [+/YESL] buttons to adjust the balance as required. The
balance range is from 0 through 20. A setting of "10" produces equal balance between the two split-
mode voices. Settings below "10" increase the volume of the Left Voice in relation to the Right
Voice, and settings above "10" increase the volume of the Right Voice in relation to the Left Voice.
Press the [–/NOM] and [+/YESL] buttons simultaneously to recall the default setting (different for
each voice combination).
• The effect depth settings cannot be changed unless the EFFECT is ON. The Function mode must be
NOTE
exited before EFFECT can be turned ON.
.........................................................................................................................................................
[FUNCTION] button while holding the [SPLIT] button.
• Split mode function settings are set individually for each voice combination.
NOTE
............................................................................................................................................
.....................................................................................................................................
............................................................................................................
..........................................................................................................
The Function Mode
29
P-80