Monitor Configuration Menu; Operation Of Switch Panels Pm4Sw10 And Pm4Sw2 - Projecta INTELLI-RV PM400 Instruction Manual

6.2.1 Monitor Configuration Menu

Figure 36 Main menu of setting
Figure 38 Battery Type setting
Figure 40 Low Voltage Protection setting
Figure 42 Restore factory setting

6.3 Operation of Switch Panels PM4SW10 and PM4SW2

6.3.1 Dimming Operation
There are three buttons on the PM4SW10 (not inc. PM435-BT) which can support brightness adjustment which is also mirrored on the
APP. They are "Ceiling light"," Bedroom light" and "Dining light" . 3 levels brightness each of them. Press and hold the button can switch
between the different brightness. Short press the button is to switch on/off the LED.
Warning: PM435-BT / PM400 dimming function may cause lights with capacitive touch switches to flicker.
The dimmable outputs are 3.5A output each. If the current is exceeded it will turn the lights on and off.
6.3.2 Scene Mode Operation
There are two modes built in PM4SW10, PM4SW2 and also the APP control.
"Night mode" on PM4SW10
Press "Night mode" is to switch on/off "Night mode". Details of "Night mode" please refer to chapter 2.11.
"Night Light" on PM4SW2
Short press the "Night light" is to switch on/off the ceiling light.
Long press the "Night light" can adjust the brightness of the ceiling light. The brightness of the ceiling light at this mode is even darker
than the darkest level of the button "Ceiling light" of PM4SW10. The brightness will be remembered for next operation.
(not inc. PM435-BT, but can be triggered via the APP)
(not inc. PM435-BT). On the APP also
Figure 37 Date and Time setting
Figure 39 Battery Capacity setting
Figure 41 Water Pump Enable/Disable setting
Figure 43 Update firmware
(not inc. PM435-BT)
21