Select Battery Switch Local/Remote; Configuration On Monitor - Projecta INTELLI-RV PM400 Instruction Manual

6.1.2 Select Battery Switch Local/Remote

This function offers a possibility for user to use a remote battery switch to power on/off the service battery output
Local
Remote
Figure 35 Local/Remote Select Switch

6.2 Configuration on Monitor

Access to the configuration menu is safeguarded with a passcode. The default is 0000 and may be set by a user.
PASSCODE DESCRIPTIONS
0000 Factory Default, no passcode
1999
Factory access passcode
XXXX User define
Press the 'Light' button until the setting code is showing on the date time area which means the monitor is ready
for configuration. The 'PUMP' button and 'LOAD' button can be used to scroll through the configuration menu.
CODE
20
DIP SWITCH DESCRIPTION
Local The switch on PM435 unit works
Remote The remote switch works and local one
is disabled
Table 20 Local/Remote Setting
FUNCTION
Time Setting
Battery Setting
Battery Type
Battery Capacity
Battery Low Voltage Protection
Pump
1
Pump 1
Pump 1 ON
Pump 1 OFF
Restore factory defaults
Cancel
Accept
Version
CMP
LCD
Cut off BlueTooth
Update enable
Table 21 Setting code of the Monitor
DESCRIPTION
Set date system 12H/24H and date.
AGM / GEL / LFP (LiFePO )/WET
4
To shutdown the output of loads
Pumps enable or disable
Select Pump 1
Pumps 1enable
Pump 1 disable
Cancel to restore factory defaults
Confirm to restore factory defaults
Software version of devices. read only
Software Version of PM435
Software Version of LCD
Shut down connection of Crystal to APP
Enable to update firmware