Yamaha MOTIF XS6 Owner's Manual page 144

Editing a Performance
Main
SpLyr Splits & Layers
FX FX
NoAsg No Assignment
n You can call up the list and select the desired item by pressing
the [SF6] LIST button. For details, see page 82.
Portamento settings—[SF2] Porta
1
2
3
1 Portamento Common*
Determines whether or not Portamento is applied to the
current Performance. When this is set to on, Portamento is
applied to the Part for which the Part Switch parameter is
set to on.
2 Portamento Part 1 – 4*
Determines whether Portamento is applied to each Part or
not.
3 Portamento Time Offset*
Determines the pitch transition time when Portamento is
applied. You can adjust Portamento time for the Voice
assigned to each Part as offset. Higher values result in a
longer pitch change time.
Settings: -64 – +63
EQ settings for each Part—[SF3] Part EQ
From this display, you can edit the value on the [F5] EQ
display (page 158) as offset to change the tonal
characteristic.
This is a three-band (Low, Mid, High) parametric EQ. The
High band and Low band are the shelving type. The
Middle band is the peaking type.
144
MOTIF XS Owner's Manual
Sub
WWind Woodwind
Brass Brass
Guitr Guitar
Bass Bass
Cperc Chromatic Percussion
Pad Pad
NoAsg No Assignment
Seq Sequence
Hard Hard
Soft Soft
S.EFX Sound Effect
NoAsg No Assignment
NoAsg No Assignment
1 2 3
4 5 6
7
Gain
+
4
0
5
1
–
3 bands
Low Middle
Frequency
Determines the center frequency. Frequencies around
each of three points are attenuated/boosted by the Gain
setting below. Higher values produce a higher frequency.
Settings: -64 – +63
1 Low Frequency
Determines the center frequency of the lower EQ band.
2 Mid Frequency
Determines the center frequency of the middle EQ band.
3 High Frequency
Determines the center frequency of the higher EQ band.
Gain
Determines the level gain for each frequency (set above),
or the amount the selected frequency band is attenuated or
boosted.
Settings: -64 – +63
4 Low Gain
Determines the amount by which signals below the Low
Frequency (1) will be boosted/attenuated.
5 Mid Gain
Determines the amount at which signals at the Mid
Frequency (2) will be boosted/attenuated.
6 High Gain
Determines the amount by which signals above the High
Frequency (3) will be boosted/attenuated.
7 Q (Bandwidth)
Determines the frequency bandwidth for each frequency
band. The larger the setting, the greater the bandwidth.
The lower the setting, the smaller the bandwidth.
Settings: -64 – +63
7
6
Frequency
2 3
High